Majdi, Seyed Mohammad, Tafti, Atefeh Ayatollahi, Demers, Vincent, Vachon, Guillem et Brailovski, Vladimir.
2022.
« Effect of powder particle shape and size distributions on the properties of low-viscosity iron-based feedstocks used in low-pressure powder injection moulding ».
Powder Metallurgy, vol. 65, nº 2.
pp. 170-180.
Compte des citations dans Scopus : 8.
Prévisualisation |
PDF
Demers-V-2022-23065.pdf - Version acceptée Licence d'utilisation : Tous les droits réservés aux détenteurs du droit d'auteur. Télécharger (6MB) | Prévisualisation |
Résumé
Low-pressure powder injection moulding (LPIM) is a cost-effective manufacturing technology used to fabricate complex-shaped parts with high mechanical properties at low- or high-volume production. This research work presents an experimental approach to investigate the debound/sintered properties of iron components produced by the LPIM process using iron-based powders exhibiting different particle shapes and size distributions. Four low-viscosity feedstocks were mixed and injected into a rectangular mould cavity before being thermally wick-debound and finally sintered using identical debinding and sintering cycles. This study confirms that both irregular and spherical iron powders can be shaped via the LPIM process. The solid loadings obtained with these two powder morphologies, varying from 58 to 62 vol.-%, represent expected values. The trend in the density values obtained with irregular (∼6.6 g/cm3) and spherical (∼7.5 g/cm3) powders was validated by metallographic observations.
| Type de document: | Article publié dans une revue, révisé par les pairs |
|---|---|
| Chercheur(-euse): | Chercheur(-euse) Demers, Vincent Brailovski, Vladimir |
| Affiliation: | Génie mécanique, Génie mécanique |
| Date de dépôt: | 24 août 2021 13:33 |
| Dernière modification: | 22 sept. 2026 13:02 |
| URI: | https://espace2.etsmtl.ca/id/eprint/23065 |
Actions (Authentification requise)
 |
Dernière vérification avant le dépôt |