Bakhtiari, Mohammad, Momen, Gelareh et Jafari, Reza.
2025.
« Photothermal polyurethane coatings with functionalized nanoparticles and quasi-liquid layer for enhanced anti-icing and solar-assisted de-icing ».
Solar Energy, vol. 300.
Prévisualisation |
PDF
Momen-G-2025-31618.pdf - Version publiée Licence d'utilisation : Creative Commons CC BY-NC-ND. Télécharger (11MB) | Prévisualisation |
Résumé
Polyurethane (PU) coatings effectively mitigate ice accumulation on surfaces in low-temperature conditions. Unlike traditional de-icing methods that can be ineffective, costly, or environmentally harmful, PU photothermal coatings offer environmental and economic benefits. They not only improve anti-icing properties and de-icing efficiency but also address critical operational and sustainability challenges associated with harsh winter environments. This study aims to develop a simple yet effective strategy for producing PU coatings with enhanced anti-icing and de-icing performance by methodically incorporating various forms of iron oxide nanoparticles—including Fe3O4 (FPU), silicone oil–coated Fe3O4 (SiFPU), and hydroxyl (OH)-functionalized Fe3O4 (FOHPU)—at concentrations from 0.5 % to 10 % to investigate their influence on mechanical, photothermal, and icephobic behavior. PU coatings were fabricated and subjected to characterization using SEM, FTIR, UV–Vis spectroscopy, and tensile testing. IR thermography was used to evaluate photothermal performance under 1 sun xenon illumination. Icephobic properties was evaluated through push-off tests in a cold room under both with and without simulated sunlight. Photothermal de-icing was assessed using simulated sunlight and push-off tests (ice adhesion strength) in a cold room, both with and without simulated sunlight. The endurance of the coatings through repeated icing/de-icing cycles was assessed. UV–Vis spectroscopy revealed improved light absorption, with the band gap of Fe3O4 nanoparticles being reduced by the silicone oil coating and hydroxyl functionalization (by 2.3 and 2.55 eV, respectively). The results indicate that the icephobic performance of PU coatings is considerably improved by using surface-functionalized nanoparticles. Also, 10FOHPU demonstrated a marked enhancement in mechanical properties, with a Young’s modulus of 140 ± 6.2 MPa and a tensile strength of 6.3 ± 0.2 MPa (compared to 106.1 ± 4.1 MPa and 6.1 ± 0.4 MPa for unmodified PU). In addition, the presence of a quasi-liquid layer on the FOHPU coatings was verified by ATR-FTIR spectroscopy conducted at sub-zero temperatures. Notably, 10SiFPU exhibited the lowest ice adhesion (40 ± 8 kPa) after 20 min of light exposure. These results highlight the potential of SiFPU and FOHPU coatings for sustainable and efficient anti-/de-icing applications. This optimized performance is facilitated by tailored nanoparticle surface chemistry.
Type de document: | Article publié dans une revue, révisé par les pairs |
---|---|
Professeur: | Professeur Momen, Gelareh |
Affiliation: | Génie aérospatial |
Date de dépôt: | 04 sept. 2025 12:58 |
Dernière modification: | 24 sept. 2025 23:10 |
URI: | https://espace2.etsmtl.ca/id/eprint/31618 |
Actions (Authentification requise)
![]() |
Dernière vérification avant le dépôt |